Flanged Turbine Meters
Flowmeters Accessories Product Selector Library
History The Factory Production Factory Calibration

Performance Data - OPTO Style Pulser
Pulsers: OD 01 - 02 - 03 - 04

Performance Data
High Frequency Pulsed Output
Type: OPTO-01/02/03/04

Description: The OPTO-01 is a 2 -wire current switching device for use with the WP/D Cold Water Meters. The   OPTO-02 is  for use with WP/D Hot Water Meters (can be used for cold water applications if needed).  This type of pulse is normally used for conversion to analog signals, (4-20mA) or inputs to high definition dosing/batching systems.

Principle: Light pulses are transmitted by an IR light diode onto a reflector wheel. The reflections are picked up by two detectors in the sensor head and processed electronically.  The micro-electronics are located in the capsule of the cable
Sensor Principle IR-reflex light barrier acc. To DIN 19234, plug type
Specification Supply voltage 8.2 Vdc
Current with reflection < 1.2 mA
Current without reflection > 2.1 mA
Forward/reverse identification integrated by an additional current barrier at 1.5mA
Pulse Duration Depending on flow in the meter
At meter stop continuous pulse possible
Protection IP 65 (DIN 40050)
Temperature Range OD 01/03: ambient temperature < 70°C

OD 02/04: medium temperature < 50°C
Connection Cable Length: 3M (10 feet)

 Pulse Values

Meter Size

2" to 4"

Dial Face: 100 USG

6" to 8"

Dial Face: 1,000 USG

10" to 12 "

Dial Face: 10,000 USG

Cold Water Meters

 OD 01 1 Pulse per 0.1 USG 1 Pulse per 1.0 USG 1 Pulse per 100.0 USG
OD 03 1 Pulse per 1.0 USG 1 Pulse per 10.0 USG 1 Pulse per 1000.0 USG

Hot Water Meters

 OD 02 1 Pulse per 0.1 USG 1 Pulse per 1.0 USG 1 Pulse per 100.0 USG
OD 04 1 Pulse per 1.0 USG 1 Pulse per 10.0 USG 1 Pulse per 1000.0 USG
 

Contact Information Resource Directory E-News Archives
Meinecke
Flanged Turbine Meters
Back Home Forward Up Email

Copyright © 2002 by Cross Instrumentation 
Specifications subject to change without notice - 10/01/02
 NOTE: The information provided above  has been compiled and published as a convenience to our customers. All technical designs, advice, and recommendations, including but not limited to, that appearing on this document are rendered free of charge. As a result, Cross Instrumentation disclaims any responsibility or liability to the buyer or user of this information for any result obtained or damages incurred by reason of the use or application of the design or other information contained herein.