Back One Page  www.crossinstrumentation.com  Forward One Page  Mail - Meinecke Information Request

Flanged Turbine Meters 

The Production Process - Internals...

In another section of the Laatzen Factory, Internals are handcrafted to exacting specifications. Individual components are produced by skilled craftsmen and then married to the bodies in a final assembly area.

 Once fully assembled, the meters move on to the Calibration Lab...
Back to: CI-Meinecke To Page 3, Calibration Back to: Body Production

For additional information, specifications or to request a quotation, 
please contact the Flow Specialists at Cross Instrumentation. 

 

Additional information on
this product(s) is available via 
the email link below:

 

Copyright © 2002 by Cross Instrumentation 
Specifications subject to change without notice - 10/01/02
 NOTE: The information provided above  has been compiled and published as a convenience to our customers. All technical designs, advice, and recommendations, including but not limited to, that appearing on this document are rendered free of charge. As a result, Cross Instrumentation disclaims any responsibility or liability to the buyer or user of this information for any result obtained or damages incurred by reason of the use or application of the design or other information contained herein.